(1) Remove old seat straps.
(2) The lower buckle is sewn into the strap. The upper buckle is angled and not sewn into the strap. Locate the lower buckle front and center on the underneath
side of the seat.
(3) Using the lower buckle as a template and a 3/32-drill bit, drill a pilot hole through the existing hole in the lower buckle approximately 1/2 inch deep in the underneath side of the seat in the exact desired location.
(4) Insert a straightened paper clip or similar device through the holes located on the back of the upper buckle and gently push out adhesive backed logo. Be careful to avoid re-sticking the logo to any other surface until the logo is reapplied in its original location.
(5) The upper buckle should be centered on the seat back and located approximately 1 inch from the top edge of the seat.
(6) Using the upper buckle as a template and a 3/32-drill bit, drill two pilot holes through the existing holes in the upper buckle approximately 1/4 inch deep in the back of the seat in the exact desired location.
(7) Install the upper buckle using the screws provided. Re-install the logo in the pocket over the 2 screw heads.
(8) When strapping down the seat back, run the strap through the underneath side of the upper buckle and back down toward the lower buckle. Pull down snug and secure.
